Search

Locator Implant Attachments are designed for use with overdentures or partial dentures retained in whole or in part by dental implants in the mandible or maxilla. Order by cuff height to match the height of the gingival tissue. The abutment will extend above the tissue by 1.8mm to allow the Locator Male to seat completely. Order one Locator Male Processing Set for each Locator Abutment (sold in packs of 2 or 10). Can also be used with tissue-level implants. Titanium Alloy. The Male Processing Package provides 3 choices of retention. The Replacement Males (clear, pink and blue) are used to restore implants with up to 10° of divergence (20° between implants). The Extended Range Replacement Males (green and red) accommodate divergences from 10° and 20° (40° between implants), and may be purchased separately. 3.5mm (Yellow) 6mm

CAMLOG® Scanbody, for optical, 3-dimensional localization of CAMLOG® Implants in the mouth or CAMLOG® Lab analogs in the working model, incl. CAMLOG® Abutment screw, sterile.Before scanning, check that the scanbody is present in the design software library used to construct the restoration. Can also be used for Platform Switching. 3.8mm (Yellow) Camlog Digital PEEK

For attaching copings to the Multi-unit abutments. Hand-tighten or torque to 15 Ncm with .050” (1.25mm) Hex Driver or Unigrip™ screw driver, depending on application. Titanium alloy. Included with copings where indicated but can also be ordered separately.

Use this valuable before-and-after TeethXpress photo album to assist with dental implant patient education and boost case acceptance. Designed for your reception area or consultation room, this book will show prospective patients how implant treatment can transform a smile and transform a life. Patient testimonials and before-and-after images are used to demonstrate single-unit and full-arch implant cases.

Multi-unit Try-in Abutments may be used to measure tissue thickness and verify proper prosthetic seating prior to final abutment seating. Each Try-in is laser marked from 1mm to 5mm to correspond with the Straight Multi-unit Abutment collar heights and can also be used as a measuring tool for other abutment types. Try-in can be carried to the site by hand or with an .050” hex driver and snaps into the implant. 3.0mm (Gray)

Prosthetic screw for bar abutment, hex, light blue anodized, also for Passive-Fit.The screw must be retightened with the corresponding torque (15Ncm) after 5 minutes. Components of the COMFOUR® Treatment Concept. 3.3mm (Gray) 3.8mm (Yellow) 4.3mm (Red) Camlog Conelog Titanium Alloy